Practice for your Cisco ICND1 100-105 dumps exam with the help of lead4pass, the best and most updated latest Cisco ICND1 100-105 dumps pdf training resources download free try. “Cisco Interconnecting Cisco Networking Devices Part 1 (ICND1 v3.0)” is the name of Cisco ICND1 https://www.lead4pass.com/100-105.html exam dumps which covers all the knowledge points of the real Cisco exam. Get your Cisco ICND1 100-105 dumps exam preparation questions in form of 100-105 PDF 100-105 ICND1 – Cisco. 100% success and guarantee to pass Cisco 100-105 exam.
Best Cisco 100-105 dumps pdf training resources free download: https://drive.google.com/open?id=0B_7qiYkH83VReEJYRlhNVjdGeVU
Best Cisco 200-105 dumps pdf training resources free download: https://drive.google.com/open?id=0B_7qiYkH83VRS3BsT2duT3pTSlU
Update latest Cisco ICND1 100-105 dumps PDF materials and Cisco 100-105 dumps vce youtube. The best useful Cisco ICND1 100-105 dumps vce software online download to have a free try.
Hot Cisco ICND1 100-105 Dumps Exam Questions And Answers (Q13-Q30)
QUESTION 13
Refer to the exhibit.
A network technician is unable to ping from R1 to R2. What will help correct the problem?
A. Ensure that the serial cable is correctly plugged in to the interfaces.
B. Apply the clock rate 56000 configuration command to the serial0/1 interface of R1.
C. Configure the serial0/1 interfaces on R1 and R2 with the no shutdown command.
D. Change the address of the serial0/1 interface of R1 to 192.1.1.4.
E. Change the subnet masks of both interfaces to 255.255.255.240.
Correct Answer: A
QUESTION 14
Which command can you enter to verify that a 128-bit address is live and responding?
A. traceroute
B. telnet
C. ping
D. ping ipv6
Correct Answer: C
QUESTION 15
Which port-security feature allows a switch to learn MAC addresses dynamically and add them to the running configuration?
A. security violation restrict mode
B. switch port protection
C. sticky learning
D. security violation protect mode
Correct Answer: C
Explanation:
You can configure an interface to convert the dynamic MAC addresses tosticky secure MAC addresses and to add them to the running configuration by enabling sticky learning. To enable sticky learning, enter the switchport port-security macaddress sticky interface configuration command. When you enter this command, the interface converts all the dynamic secure MAC addresses, including those that were dynamically learned before sticky learning was enabled, to sticky secure MAC addresses.
QUESTION 16
Which transport layer protocol is best suited for the transport of VoIP data?
A. RIP
B. UDP
C. TCP
D. OSPF
E. HTTP
Correct Answer: B
QUESTION 17
CORRECT TEXT
How do you bypass password on cisco device?
A. Change the configuration register to 0x2142. With this setting when that router reboots, it bypasses the startup-config and no password is required.
Correct Answer: A
QUESTION 18
Refer to the exhibit.
What value should be displayed in Box 1 of the ipconfig output of host A?
A. 172.18.14.5
B. 172.18.14.6
C. 192.168.1.10
D. 192.168.1.11
E. 192.168.1.250
F. 192.168.1.254
Correct Answer: F
QUESTION 19
In which two ways does TCP differ from UDP? 100-105 dumps (Choose two.)
A. TCP segments are essentially datagrams.
B. TCP uses broadcast delivery.
C. TCP provides sequence numbering of packets.
D. TCP provides synchronized communication.
E. TCP provides best effort delivery.
Correct Answer: CD
Explanation:
Before two computers can communicate over TCP, they must synchronize their initial sequence numbers (ISN)
TCP uses a sequence number to identify each byte of data. The sequence number identifies the order of the bytes sent from each computer so that the data can be reconstructed in order, regardless of any fragmentation, disordering, or packet loss that may occur during
QUESTION 20
What is true about ipv6 unique local addresses:
A. Global id
B. Public routable
C. Summarization
D. Unique prefix
Correct Answer: D
QUESTION 21
Which two VLANs are reserved for system use only? (Choose two)
A. 1
B. 4095
C. 4096
D. 0
E. 1001
Correct Answer: BD
Explanation:
The VLANs 0 and 4095 are reserved by the IEEE 802.1Q standard and you cannot create, delete, or modify them so they are the correct answers.
Note:
+ VLAN 0 and 4095 are reserved for system use only. You cannot see or use these VLANs.
+ VLAN 1 and VLANs 1002-1005 are default VLANs. Default VLANs are created automatically and cannot be configured or deleted by users. + VLAN 2 to 1001 are normal VLANs. You can create, use and delete them. + VLAN 1002 to 1005 are normal VLANs too but Cisco reserved for FDDI an Token Ring.
QUESTION 22
Which function enables an administrator to route multiple VLANs on a router?
A. IEEE 802 1X
B. HSRP
C. port channel
D. router on a stick
Correct Answer: D
QUESTION 23
Which feature automatically disables Cisco Express Forwarding when it is enabled?
A. multicast
B. IP redirects
C. RIB
D. ACL logging
Correct Answer: D
Explanation:
If you enable CiscoExpress Forwarding and then create an access list that uses the logkeyword, the packets that match the access list are not Cisco Express Forwarding switched. They are process switched. Logging disables Cisco Express Forwarding.
QUESTION 24
When troubleshooting a LAN interface operating in full duplex mode, which error condition can be immediately ruled out?
A. giants
B. no buffers
C. collisions
D. ignored
E. dribble condition
Correct Answer: C
QUESTION 25
Refer to the exhibit.
What does the address 192.168.2.167 represent?
A. the TFTP server from which the file startup-config is being transferred
B. the router from which the file startup-config is being transferred
C. the TFTP server from which the file router-confg is being transferred
D. the TFTP server to which the file router-confg is being transferred
E. the router to which the file router-confg is being transferred
F. the router to which the file startup-config is being transferred
Correct Answer: D
QUESTION 26
Which statement about unicast frame forwarding on a switch is true?
A. The TCAM table stores destination MAC addresses
B. If the destination MAC address is unknown, the frame is flooded to every port that is configured in the same VLAN except on the port that it was received on.
C. The CAM table is used to determine whether traffic is permitted or denied on a switch
D. The source address is used to determine the switch port to which a frame is forwarded
Correct Answer: B
QUESTION 27
What is the maximum number of bits that can be borrowed to create subnets if a Class B network address is being used?
A. 2
B. 6
C. 8
D. 14
E. 16
Correct Answer: D
QUESTION 28
Which NTP command configures the local device as an NTP reference clock source?
A. ntp peer
B. ntp broadcast
C. ntp master
D. ntp server
Correct Answer: D
QUESTION 29
Which technique can you use to route IPv6 traffic over an IPv4 infrastructure?
A. NAT
B. 6to4 tunneling
C. L2TPv3
D. dual-stack
Correct Answer: B
QUESTION 30
When you use the ping command to send ICMP messages across a network, what’s the most common request/reply pair you’ll see? (Select one answer choice)
A. Echo request and Echo reply
B. ICMP hold and ICMP send
C. ICMP request and ICMP reply
D. Echo off and Echo on
Correct Answer: A
Lead4pass is the best provider of IT learning materials and the right choice for you to prepare for Cisco 100-105 exam. Lead4pass provide the latest real questions and answers with lowest prices, help you pass Cisco 100-105 exam easily at first try.
The Following Are Some Reviews From Our Customers:
High quality Cisco ICND1 100-105 dumps pdf training resources which are the best for clearing https://www.lead4pass.com/100-105.html exam test, and to get certified by Cisco ICND1. If you want to get success with good grades then these Cisco ICND1 100-105 dumps exam question and answers are splendid platform for you I personally review this web many times that’s why I am suggesting you this one.
New Cisco ICND1 100-105 dumps vce youtube:
https://youtu.be/wuQgBRPR4rg